It is inevitable that the handle hoist will encounter wet water when it is used for outdoor lifting operations. What should be done when the handle hoist encounters wet water? Next, we will make suggestions for you.

In case of water ingress into the chain block, the cover surface and visible parts shall be wiped clean first; Then use a hair dryer to blow against the chain mouth to speed up the air drying. If the water ingress is serious, it is necessary to completely remove the cover of the chain block, and then dry it in the air. After it is confirmed to be completely dry, apply lubricating grease on the internal parts before continuing to use.

If the manual hoist is not dried after water ingress, the internal parts of the manual hoist will rust, increase the wear between parts, and reduce the service life. Although there is a waterproof coating on the surface of the chain block, water ingress should be avoided as much as possible in the process, so as to maximize the service life of the chain block